Talk:LXD configuration for OSM Release THREE

For the MTU configuration after LXD configuration I propose user to run the following:

# get main interface MTU
DEFAULT_INTERFACE=$(route -n | awk '$1~/^0.0.0.0/ {print $8}')
DEFAULT_MTU=$( ip addr show $DEFAULT_INTERFACE | grep -i -E "(MTU|mtu)(:| +)[0-9]+" -o | grep -E "[0-9]+" -o )
# set lxc MTU if diferent from 1500
[ "$DEFAULT_MTU" -ne 1500 ] && lxc profile device set default eth0 mtu $DEFAULT_MTU

Not needed to set mtu of lxdbr0 mtu xxxx. Just editing lxc default profile is enough and it is permanent

---

This is the new MTU section

MTU

Check the MTU of the LXD bridge (lxdbr0) and the MTU of the default interface. If they are different, change the default MTU of the containers.

Note: In this example, we will assume that the default interface is ens3 and its MTU is 1446

lxc list                                              # This will drive initialization of lxdbr0
ip address show ens3                                  # In case ens3 is the default interface
ip address show lxdbr0
sudo lxc profile device set default eth0 mtu 1446     # Use the appropriate MTU value